09-24-2008 05:22 AM - edited 03-03-2019 11:40 PM
When I try and go into enable mode I enter the password and I get %Error in authentication. Any thoughts? I was in the router eailier and used the same password as I am now and it worked no problem.
Mike
09-24-2008 05:47 AM
You may have to reset it. What was the last thing you did it it, and are you consoled or terminaled into it?
John
09-24-2008 05:48 AM
Oh, and I meant reset the password on the router if you can't get into it.
09-24-2008 05:58 AM
I tried both telnet and console both with the same results. The last thing I did was to show int and show run....I did not change or save anything.
Mike
09-24-2008 06:16 AM
That's weird. You may have to reset the password through a console connection.
Here's a link:
--John
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide