QoS Setup issue

Answered Question

When setting up QoS on a 2801, I get the following error when trying to apply the service-policy to the interface.

I/f Serial0/1/0:0 class CRITICAL requested bandwidth 49%, available only 25%

The service provider only provides me with a 50%/49% QoS policy to work with. Attached is the QoS config I'm trying to use. Every time I try to run the last step, I get the same error.

Attachment: 
I have this problem too.
0 votes
Correct Answer by jon.harald.bovr... about 8 years 2 months ago

Hi

by default it is possible to reserve 75%, with 25% avaliable for default class.

command max-reserved-bandwidth changes default

Try

int ser 0/1/0:0

max-reserved-bandwidth 99

Service-policy out xxx

Jon

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
Correct Answer
jon.harald.bovr... Wed, 09/24/2008 - 09:27

Hi

by default it is possible to reserve 75%, with 25% avaliable for default class.

command max-reserved-bandwidth changes default

Try

int ser 0/1/0:0

max-reserved-bandwidth 99

Service-policy out xxx

Jon

Actions

This Discussion