ASA in HA (Active/Standby failover) but only one IPS module

Answered Question
Sep 24th, 2008
User Badges:

Hi folks,

Will I have a chance to configure active/standby failover with a pair of ASAs but only one of them will have AIP-SSM module? I know it is a requirement that the two ASAs are exactly the same from HW and SW perspective, but not sure if that would include IPS module. Obviously IPS will not work if the primary device fails, but that's OK.


Hopefull

Eugene

Correct Answer by suschoud about 8 years 6 months ago

Unfortunately failover would not work with 1 ips module.


Either you should have two,oryou would need to remove one from asa.


Do rate helpful posts.



Regards,

Sushil

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
Correct Answer
suschoud Wed, 09/24/2008 - 13:58
User Badges:
  • Gold, 750 points or more

Unfortunately failover would not work with 1 ips module.


Either you should have two,oryou would need to remove one from asa.


Do rate helpful posts.



Regards,

Sushil

Actions

This Discussion