Buy or Renew
Buy or Renew
Cisco Virtual Engineer generative AI bot now active in Wireless Discussion Forum. Learn more.
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
381
Views
0
Helpful
4
Replies

802.11n upgrades

lonnylegrand99
Level 1
Level 1

‎09-25-2008 06:17 AM - edited ‎07-03-2021 04:31 PM

I'm looking into upgrading current Cisco 1232 (G) to an (N) solution. Can I upgrade the 1232 with a radio change only or will the 1232 not accept the change? Will I have to replace the 1232 with a 1252.

If anyone has a white paper on this it would be very helpful.

Lonny

Labels:
0 Helpful
4 Replies 4

grzegorz.ciolek
Level 1
Level 1

‎09-25-2008 12:12 PM

Hi

There is no N module for 1232

You have to replace AP.

Cheers

Greg

0 Helpful

lonnylegrand99
Level 1
Level 1
In response to grzegorz.ciolek

‎09-25-2008 12:30 PM

After a little bit of research I found this out. Thanks for your reply though.

Lonny

0 Helpful

Lucas Phelps
Level 5
Level 5

‎10-08-2008 07:25 AM

There is no upgrade module to upgrade the 1232 to an N radio. I'm assuming the reason being is that older radios did not require multiple antenna connectors like the 1252 N Access Point needs. N radios need 3 Connectors per radio.

0 Helpful

jeff.kish
Level 7
Level 7
In response to Lucas Phelps

‎10-08-2008 08:20 AM

Actually, you can run 802.11n with 2 antennas (2x2 mode). But yes, the primary reason that 1232s cannot be upgraded is due to hardware restrictions.

0 Helpful
Customers Also Viewed These Support Documents
Review Cisco Networking products for a $25 gift card