09-25-2008 06:17 AM - edited 07-03-2021 04:31 PM
I'm looking into upgrading current Cisco 1232 (G) to an (N) solution. Can I upgrade the 1232 with a radio change only or will the 1232 not accept the change? Will I have to replace the 1232 with a 1252.
If anyone has a white paper on this it would be very helpful.
Lonny
09-25-2008 12:12 PM
Hi
There is no N module for 1232
You have to replace AP.
Cheers
Greg
09-25-2008 12:30 PM
After a little bit of research I found this out. Thanks for your reply though.
Lonny
10-08-2008 07:25 AM
There is no upgrade module to upgrade the 1232 to an N radio. I'm assuming the reason being is that older radios did not require multiple antenna connectors like the 1252 N Access Point needs. N radios need 3 Connectors per radio.
10-08-2008 08:20 AM
Actually, you can run 802.11n with 2 antennas (2x2 mode). But yes, the primary reason that 1232s cannot be upgraded is due to hardware restrictions.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: