Failsafe message on Unity 4.2 UM with Exch2003

richb1971 · ‎09-25-2008

Hi folks,

Had a couple of users getting the failsafe. Dbwalker suggested removing and re-adding the Subscribers. Removed one but cannot add them back. Tried BunnyKiller but it would not remove Unity Attributes so could not re-add. Tried a reynch which caused FailSafe for all users-joy. Noticed all users have no LocationObjectId. Any ideas? please!

Rich

richb1971 · ‎09-25-2008

Correction: Users hear the 'welcome to Cisco Unity' rather than a prompt to login. They did have the login prompt earlier but was lost on resynch.

Tommer Catlin · ‎09-25-2008

Did something change in your Active Directory? It sounds like the subscribers in AD are messed up or? I would do the following:

Download and re-run permissions wizard

re-run Mailstore wizard

Check your DCGC connect. Force connect and sync.

Check the event log for errors. Do you see any?

richb1971 · ‎09-25-2008

Hi,

Thanks for reply. Tried those-no joy. The Subscribers seem to have lost their LocationId but I don't know how to get it back.

Rich

Tray Stoutmeyer · ‎09-26-2008

If all of your other users that work are located on the same Unity server then you should be able to go into the SQL table and copy/paste their locationid into the affected users that don't have one. IF you have several locations, then you just need to find a subscriber that is located on the same Unity as the one's that are missing theirs and copy that locationid in there. Try that.

Tray

richb1971 · ‎10-01-2008

TAC suspect some Unity attributes are missing from AD somehow. Tried re-install-Planning to re-run ADschemaupdate on Friday. Customer is reluctant but can't see any other way around it.

Any other suggestions?