Policy Based routing

Unanswered Question
Sep 25th, 2008
User Badges:

Hi,

We have situation where we have static route in switch 1 pointing toward a location A, we have new requirement were we have to route a traffic toward a alternate path B where we have 2 routers in between switch 1 and path B.

We have used the policy based routing on the switch 1 pointing toward the router1, we are able to push the traffic toward the router1 and from router1 were need to push it router2 where path B is connected.

We are able to see the hits on the route map created on the router1 but we are not able to see the traffic going outside the router1.

Please help us in resolving the issue.


  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Jon Marshall Thu, 09/25/2008 - 11:27
User Badges:
  • Super Blue, 32500 points or more
  • Hall of Fame,

    Founding Member

  • Cisco Designated VIP,

    2017 LAN, WAN

Could you explain the topology a little more, together with the source/destination IP addresses.


Jon

Actions

This Discussion