Buy or Renew
Buy or Renew
Duo Security forums now LIVE! Get answers to all your Duo Security questions. Learn more
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
465
Views
0
Helpful
4
Replies

pager line 0 problem

Satya Siba Sundar Mishra
Level 1
Level 1

‎09-25-2008 12:19 PM - edited ‎03-11-2019 06:49 AM

i have pix 515E bundle running 6.3(5) version.it is taking "no pager" by default. when i am configuring pager line as 24, it will taking this length but after some time(5-7 mins),again the pager line goes to 0. Simaltaneously when i am trying to do "write memory" sometime it is accepting the command and sometimes not "flash is used by another task". but everything is running fine on standby pix.

Labels:
0 Helpful
4 Replies 4

suschoud
Cisco Employee
Cisco Employee

‎09-25-2008 12:22 PM

Satya,

Looks like flash has gone bad.Time to replace the good old PIX.

Everything would run fine on standby pix as it has a different hardware.

Regards,

Sushil

0 Helpful

Satya Siba Sundar Mishra
Level 1
Level 1
In response to suschoud

‎09-25-2008 12:46 PM

i found one solution that by enabling ssh ver 2, we can solve the problem.can you please suggest me how can i check the currrent version of ssh in pix(6.3)

0 Helpful

suschoud
Cisco Employee
Cisco Employee
In response to Satya Siba Sundar Mishra

‎09-25-2008 12:56 PM

As far as I remember,pix running 6.x will not support version 2.0

It supports version 1.0 and 1.5

Reagrds,

Sushil

0 Helpful

Satya Siba Sundar Mishra
Level 1
Level 1
In response to suschoud

‎09-25-2008 01:07 PM

it is taking command to enable ssh ver 2, but i am not sure how to check the current version of ssh

0 Helpful
Customers Also Viewed These Support Documents
Review Cisco Networking products for a $25 gift card