failover from active to standby call server(cvp) taking long time.

Unanswered Question
Sep 25th, 2008

Hi all

We have 2 vxml gateways pointing to 2 vxml servers.The servers are in active and standby as configured on vxml gw.When vxml1 is taken out of the network it takes 9 to 10 sec for the new calls to get connected to vxml server 2.This is the case with welcome prompts (micro-apps) as well as the application prompts.Is there any ways by which we can reduce this time.Also attached is the configs on the vxml gw1.

Attachment: 
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
geoff@hp.com Fri, 09/26/2008 - 14:41

Your dial peers are a bit strange. You have

"session protocol sipv2"

but why don't you say

"session target sip-server"?

I'm not saying it won't work without that statement, but I always use it.

You could also turn down the sip-ua on other retries:

retry response 2

retry bye 2

retry cancel 2

Regards,

Geoff

Actions

This Discussion