cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
347
Views
0
Helpful
3
Replies

Site to Site VPN Mail between sites not flowing

bob.bartlett
Level 1
Level 1

Have a site to site tunnel between routers and the mail between the sites won't flow both are exchange servers in the same routing group. I have to tunnel between the sites wide open IP and still nothing.

3 Replies 3

andrew.prince
Level 10
Level 10

post the configuration of both sides.

Danilo Dy
VIP Alumni
VIP Alumni

Do you have ACL in the interface where VPN use to establish connection? Try removing the interface ACL, if it works, add the IP Address of the VPN to the permit entries of the interface ACL, re-apply the ACL to the interface.

ajagadee
Cisco Employee
Cisco Employee

Hello Bob,

Couple of things you can..

1. If ICMP is permitted, ping between the mail servers and see if they can see each other through the tunnel.

2. Make sure that SMTP Ports are not blocked anywhere between the servers.

3. Configure Capture command on the mail traffic and see if you the packets are making to the ASAs.

Regards,

Arul

** Please rate all helpful posts **

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: