ospf info on router

Unanswered Question
Sep 27th, 2008

hi all, if I want to see what my hold time and hello timers are for ospf, what do i need to type ?

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
vishal_bhugra Sat, 09/27/2008 - 19:29

Hi Carl

Show Ip Ospf interface ... helps you in that case

Router#sh ip ospf interface

Vlan X is up, line protocol is up

Internet Address x.x.x.x/x, Area x Process ID 1, Router ID x.x.x.x, Network Type BROADCAST, Cost: 1

Transmit Delay is 1 sec, State DR, Priority 1

Designated Router (ID) x.x.x.x, Interface address x.x.x.x

No backup designated router on this network

Timer intervals configured, Hello 10, Dead 40, Wait 40, Retransmit 5

oob-resync timeout 40

No Hellos (Passive interface)

HTH

Vishal Bhugra

Actions

This Discussion