09-27-2008 02:05 AM - edited 03-06-2019 01:38 AM
hi all, if I want to see what my hold time and hello timers are for ospf, what do i need to type ?
09-27-2008 04:24 AM
Hello Carl,
use
sh ip ospf interface [type x/y]
hope to help
Giuseppe
09-27-2008 07:29 PM
Hi Carl
Show Ip Ospf interface ... helps you in that case
Router#sh ip ospf interface
Vlan X is up, line protocol is up
Internet Address x.x.x.x/x, Area x Process ID 1, Router ID x.x.x.x, Network Type BROADCAST, Cost: 1
Transmit Delay is 1 sec, State DR, Priority 1
Designated Router (ID) x.x.x.x, Interface address x.x.x.x
No backup designated router on this network
Timer intervals configured, Hello 10, Dead 40, Wait 40, Retransmit 5
oob-resync timeout 40
No Hellos (Passive interface)
HTH
Vishal Bhugra
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: