I would like to limit the internet access bandwith for guest users on a Catalyst 3750 Stack (see attachment for layout) in the core.
I saw that this is possible with the srr-queue limit command, but as I understand, this is relative value to the link attached, in our case the FortiGate FW is attached to an Gigabit Ethernet port. So if i would configure a value of 10, then the limit rate would be 10% of 1'000'000'000 ~= 100 Mbit/s right?!
What I would like to have is, that the guest users (wired and wireless) only have 2 out of 6 Mbit/s for the internet access. Can you please help my, on how to configure this?
Thanks in advance for your help!
as it shown in ur topology u have firewall
now the srr-queue is sechdualing methoed rathar than policing method
u can limit the bandwith based on source IPs two ways
first limit it on te switch by useing policing
or u can make the bandwidth managment on the internet edge device
on the firewall outise interface u can based on source IP make the limitations
if u use cisco ASA the following link is the solution:
for bandwidth managment and rate limit on switch have a look at the foolwoing post of min regarding a similer case to urs:
if helpful Rate