Dynamic map and VTI on 1841

Unanswered Question
Sep 28th, 2008
User Badges:

I am trying to setup a 1841 router to accept VPN from remote PC.I want to use a dynamic map,as i dont know the IP addresses that will be used.But, i cannot associate the dynamic map with a VTI.Is that possible?

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Marwan ALshawi Mon, 09/29/2008 - 04:18
User Badges:
  • Purple, 4500 points or more
  • Community Spotlight Award,

    Best Publication, December 2015

u need to have conif gsimiler to :


crypto isakmp client configuration group easyvpn-group

key

dns

wins

domain cisco.com

pool easyvpn-pool

acl ezvpn_split_tunnel



crypto isakmp profile easyvpn-group

description PSK group

match identity group easyvpn-group

client authentication list easyVPN

isakmp authorization list easyVPN

client configuration address respond

virtual-template 1


crypto ipsec transform-set t1 esp-3des esp-sha-hmac

crypto ipsec profile prof

set transform-set t1


interface Virtual-Template1 type tunnel

description EasyVPN for PSK users

ip unnumbered GigabitEthernet0/0

ip pim sparse-mode

tunnel mode ipsec ipv4

tunnel protection ipsec profile prof


where the "GigabitEthernet0/0" should be ur outisde interface


and the above aonly example just have a look at the commands ...


good luck

if helpful Rate

Actions

This Discussion