09-29-2008 01:40 AM - edited 03-09-2019 09:34 PM
Hi Expert, I Have a situation where a 2811 is configured with 2 VLANs from HWIC-4ESW module, different ports configured, however the VLAN interfaces have the same mac-address with fa0/0 which causes ARP poisoning problem. It that anyway to solve this problem?
09-29-2008 02:27 AM
Contact Cisco TAC.
09-29-2008 07:31 PM
Hi Lee,
My understanding is, this is expected behavior and is due to the hardware limitation of the HWIC-4ESW Module. And I think the HWIC-4ESW Module (at least from my lab testing) always takes the MAC Address of the first on board LAN Interface.
Also, I am able to change the MAC Address of the first on board LAN Interface (Ex.Gig0/0) but I cannot change the MAC Address of the VLAN SVI.
I hope it helps.
Regards,
Arul
** Please rate all helpful posts **
10-05-2008 09:47 PM
Hi Arul,
Thank's for your reply. Does it mean that no solution to aviod the ARP poisoning issue?
Regards
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: