Reassembly limit exceeded

Answered Question

Hi, wonder if anyone could help with this issue... we have recently upgraded to version 8 from version 6 on PIX

When connected to Oracle servers over a VPN tunnel it bombs out with errors, looking on the PIX log (attached) showed a reassembly limit is exceeded. I've looked on the web and found a work around is to remove 'inspect rstp'

i have done this but the errors persists

It did'nt happen on version 6.3 any ideas?

I have this problem too.
0 votes
Correct Answer by suschoud about 8 years 3 months ago

Please remove " inspect sqlnet " too.

Do rate if it resolves the issue.

Regards,

Sushil

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (2 ratings)
Loading.
jjohnston1127 Mon, 09/29/2008 - 07:14

Please provide a running configuration of your device also.

You can try this command:

set connection embryonic-conn-max 16384

Correct Answer
suschoud Mon, 09/29/2008 - 07:17

Please remove " inspect sqlnet " too.

Do rate if it resolves the issue.

Regards,

Sushil

abinjola Mon, 09/29/2008 - 08:12

Jmoss..removing Inspect wont help..you are getting reassembly limit exceeded error because tcp-proxy function/Inspection is enabled..and as TCP Proxy is mandatory for certain inspected protocols SIP, Skinny, H.323,RTSP disabling it wont help...

your problem is this CSCsl15229

Rate if this was helpful...

abinjola Mon, 09/29/2008 - 08:13

Jmoss..removing Inspect wont help..you are getting reassembly limit exceeded error because tcp-proxy function/Inspection is enabled..and as TCP Proxy is mandatory for certain inspected protocols SIP, Skinny, H.323,RTSP disabling it wont help...

your problem is this CSCsl15229

Rate if this was helpful...

abinjola Mon, 09/29/2008 - 20:49

this was a feature enhancement request...you may go to any of these codes..

8.0(4.1)

8.2(0.141)

8.1(101.6)

8.1(1.10

plz rate if it helps !

Actions

This Discussion