Buy or Renew
Buy or Renew
Cisco Virtual Engineer generative AI bot now active in Wireless Discussion Forum. Learn more.
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
298
Views
0
Helpful
2
Replies

Authenticate users by Windows group using ACS

jwilliams
Level 1
Level 1

‎09-29-2008 07:47 AM - edited ‎07-03-2021 04:32 PM

Currently we are using Windows IAS/RADIUS to authenticate users onto out wireless network and it is set to allow users in a certain Windows group to connect.

Is there a way to do this with ACS?

Please note that we are using ACS Solution Engine, not ACS for Windows.

Thanks.

Labels:
0 Helpful
2 Replies 2

Premdeep Banga
Level 7
Level 7

‎09-30-2008 01:57 PM

Use Remote Agent for Windows user authentication feature or configure Windows AD as the LDAP on ACS SE.

then configure group mapping, and put the restrictions accordingly.

Regards,

Prem

Please rate if it helps!

0 Helpful

jcrussell
Level 3
Level 3
In response to Premdeep Banga

‎10-02-2008 05:47 AM

pbanga: I found your other post about how to configure Windows as LDAP. Thanks!

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents
Review Cisco Networking products for a $25 gift card