PBR problems

Answered Question
Sep 29th, 2008
User Badges:

Hi,

I'm trying to set up a PBR on my 4506 switch: (Cisco IOS Software, Catalyst 4500 L3 Switch Software (cat4500-IPBASEK9-M), Version 12.2(31)SGA, RELEASE SOFTWARE (fc3))


But, when I'm on the interface line configuration: [swcore(config-if)] the switch doesn't accept the command "ip policy route-map IT", it appears the switch doesn't have the command.


And I just have configured the access-lis t and i'vve created the route map IT.


I think its because the IOS version.


What could be the cause?


Thanks


Tauer

Correct Answer by Jon Marshall about 8 years 7 months ago

Tauer


I don't believe PBR is supported on the Sup II+ as this supervisor is really a L2 sup with only some basic L3 capabilities.


The SupIV would support PBR as it is a L2/L3 supervisor.


The difference between BASE and Enterprise is primarily enhanced L3 routing eg EIGRP/OSPF/BGP and some additional L3 functions such as PBR.


Jon

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
Jon Marshall Mon, 09/29/2008 - 13:05
User Badges:
  • Super Blue, 32500 points or more
  • Hall of Fame,

    Founding Member

  • Cisco Designated VIP,

    2017 LAN, WAN

Tauer


Which supervisor are you running ?


Regardless i don't believe PBR is supported in the IPBASE version. You need the Enterprise version of code.


Jon

Tauer Drumond Tue, 09/30/2008 - 03:17
User Badges:

Hi Jon,

I'm running the Supervisor IV.


What is the diference between both...IPBASE and Enterprise?


Thanks


Tauer

Correct Answer
Jon Marshall Tue, 09/30/2008 - 05:50
User Badges:
  • Super Blue, 32500 points or more
  • Hall of Fame,

    Founding Member

  • Cisco Designated VIP,

    2017 LAN, WAN

Tauer


I don't believe PBR is supported on the Sup II+ as this supervisor is really a L2 sup with only some basic L3 capabilities.


The SupIV would support PBR as it is a L2/L3 supervisor.


The difference between BASE and Enterprise is primarily enhanced L3 routing eg EIGRP/OSPF/BGP and some additional L3 functions such as PBR.


Jon

limtohsoon Sat, 03/28/2009 - 19:28
User Badges:

Hi Jon,


I have a Catalyst 4507R with Sup V.


Platform: CAT4500-SUP5

IOS: 12.2(31)SGA4

Feat.set: ENTERPRISE SERVICES SSH


It supports the normal PBR. I'm looking for support of PBR Recursive Next Hop. Do you know if the higher version of IOS, e.g. 12.2(50)SG1, supports this feature?


Feature Navigator says it is not supported on a CAT4500 platform. But Feature Navigator can be inaccurate sometimes.


Please advise.



Thank you.


B.Rgds,

Lim TS


Actions

This Discussion