CCME IOS - 12.4(20)T dual-line

Unanswered Question
Sep 30th, 2008
User Badges:

I have ephone-dn configured in dual-line mode.

My users start complaining because when they use a phone and someone else is calling, the calling person doesn't hear busy signal.

It is possible to use dual-line mode and setup busy signal when someone else is calling on the used number?

I' can't find any useful command to setup this.

I will be appreciate for any help

Best


  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Rob Huffman Tue, 09/30/2008 - 04:16
User Badges:
  • Super Red, 40000 points or more
  • Hall of Fame,

    Founding Member

  • Cisco Designated VIP,

    2017 IP Telephony, Unified Communications

Hi Robert,


Because the DN's are set up as dual-line you need to add the following (huntstop channel command). Have a look;


The following example creates an ephone-dn with the number 103 in dual-line mode. The no huntstop command allows calls to continue to hunt to other ephone-dns if this one is busy or does not answer. The huntstop channel command disables call hunting to the second channel of this ephone-dn if the first channel is busy or does not answer.


Router(config)# ephone-dn 10 dual-line


Router(config-ephone-dn)# number 103


Router(config-ephone-dn)# no huntstop


Router(config-ephone-dn)# huntstop channel


Router(config-ephone-dn)# exit


From this CME doc;


http://www.cisco.com/en/US/products/sw/voicesw/ps4625/products_command_reference_chapter09186a0080611350.html#wp1056194


Hope this helps!

Rob


Actions

This Discussion