Dont see default_inspection protocol

Unanswered Question
Sep 30th, 2008

Hi, We have ASA 5505 installed in Production and I want to add ICMP in default_inspection but when I execute sh run command then I don't see any default_inspection rule. Please advice

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
JORGE RODRIGUEZ Tue, 09/30/2008 - 15:30

there should be class inspection default under global_policy


fw#show run | inc class inspection_default

output of above should be class inspection_default if no output then

create one, but again class inspection_default should be there in global policy as

all protocol inspection is under this global policy that cames as default.

fw(config)#policy-map global_policy

fw(config-pmap)#class inspection_default

fw(config-pmap-c)#inspect icmp


fw#wr mem



JORGE RODRIGUEZ Wed, 10/01/2008 - 13:50

Richard, glad is resolved, and as usual PLS contribute the good netpro cause in rating helpful posts.

Bst Rgds



This Discussion