Extending wireless to AP in order to extend network

Unanswered Question
Oct 1st, 2008
User Badges:

All I have a design and configuration question in regards to setting up a building that has no wired connections to the network. I have an AP that I would like to setup in there, however, I cannot figure out how to connect that AP in the remote building with the AP in the building connected to the wired LAN. My antennas are setup, but I cannot figure out how to configure this connectivity, to basically extend the network to this building through the wireless connection. Sort of like a point to point connection or bridge extension of the network. We are using LWAPP with WiSM.


Any ideas?

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Scott Fella Wed, 10/01/2008 - 15:34
User Badges:
  • Super Silver, 17500 points or more
  • Hall of Fame,

    The Hall of Fame designation is a lifetime achievement award based on significant overall achievements in the community. 

  • Cisco Designated VIP,

    2017 Wireless

Since you have an lwapp deployment, what you would need to do is setup a point to point bridge to connect the two buildings then you can setup the other LAP in the other building either in local or h-reap mode.

Actions

This Discussion