Cisco ASA 5505 - locks up after about 2 days uptime

Unanswered Question
Oct 1st, 2008

I am using a ASA 5505 with two IPSec Tunnels & Remote users IPSec VPN's. I am finding that the unit locks up after about 2 days uptime. It remains visible locally so I can do an immediate system reload but there is no internet access, the tunnels gop down & the remote VPN users are unable to connect. After the system reload the unit is fine again until the next time. If I reload unit via ASDM it works for few minutes and locks again. But after power off/on it works for few days. Unit Version is 7.2(4).

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
suschoud Thu, 10/02/2008 - 06:54

check interface speed and duplex settings.hard code it and avoid auto settings.

also,change the outside interface from e0/0 port to some other port.that would confirm if it's the e0/0 port which is bad.

Regards,

Ssuhil

Actions

This Discussion