Automatically apply LWAPP template to new WAP based on IP address

Unanswered Question
Oct 2nd, 2008

Hello

Is it possible to get a WiSM to automatically apply an LWAPP template based on the acecss point IP address?

We are growing our network and will soon have 8 WiSM blades and I would love to be able to plug an access point into a socket, get it to pick up an IP from a specific subnet and then automatically recieve the template defining its primary and secondary controllers etc.

Is this possible, I have looked but can't seem to find how to do it? Can anyone help me?

regards

Bryn

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Scott Fella Sun, 10/05/2008 - 07:34

That is not possible... What can make is simple is to have WCS. This way you cna create a template with primary and secondary for your diffrent ap clusters and push that out. Works well if you ask me, especially when you have a bunch of wlc's and ap's you have to manage.

jcosgrove Mon, 10/06/2008 - 04:12

Is there a way to run a report or verify which AP's are currently running which template? It seems to be a one way push that you can't verify. Also it would be nice if there were better ways to classify AP's into groups

Actions

This Discussion

 

 

Trending Topics: Other Wireless Mobility

client could not be authenticated
Network Analysis Module (NAM) Products
Cisco 6500 nam
reason 440 driver failure
Cisco password cracker
Cisco Wireless mode