10-02-2008 11:11 PM - edited 03-03-2019 11:46 PM
Hi Gurus,
I have a requirement here.
Old Setup:
3com with gbic and using multimode fiber
New Setup:
-at least 8 port that supports SC and multimode
- 24 port FastEth
tnx.
10-03-2008 12:21 AM
1.Your 8 fiber port requirement can be fulfilled only by using Chassis switch like 4500 or 6500, where you can have one blade/module of ethernet ports & one module/blade of GBIC/SFP ports.
2.But other option is Using 2 catalyst 3750 , switches one all UTP/RJ-45 & other all fiber ports , stack both switches using stack cable.
Cisco Catalyst 3750 - 24TS
24 Ethernet 10/100 ports and 2 small form-factor pluggable (SFP) ports
Cisco Catalyst 3750G-12S
12 SFP ports
3.None of one U the switch is having 8 ports as fiber.
HTH..rate if helpful..
10-03-2008 12:38 AM
Hi Satish,
Is there any switch with 8 GBIC modules? another thing if i use SFP, i need to have a SC-LC for it, and it should also be multimode right ?
Thanks.
10-03-2008 01:37 AM
Hi,
1.Below is the switch with 10 GBIC
Catalyst 3550-12G Switch-10 GBIC-based Gigabit Ethernet ports and two 10/100/1000BASE-T ports; 1.5 RU
2.Hi , it depends on what the device is taking
Fiber Cables will be available in both types
SC-LC as well as LC-LC , both single mode & multimode depends on the distance between end devices.
HTH..rate if helpful..
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: