Solved: How to create client/server VLANs after FWSM towards ACE Module

new_networker · ‎10-03-2008

Hi,

In the concerned design, the client/server vlans are on the inside of the FWSM. So for e.g. FWSM inside is VLAN100 which receives client hits which also has the servers connected.

I believe a different vlan needs to be created for the client and servers such as VLAN100 for client and VLAN101 for servers and then these should be bridged.

Now, VLAN100 is shared between FWSM inside and ACE Client. So, how will the vlan-group be defined on the MSFC in this scenario.

Regards.

Syed Iftekhar Ahmed · ‎10-03-2008

I posted an answer on the same issue a while ago.

Following is the link

http://forum.cisco.com/eforum/servlet/NetProf?page=netprof&forum=Data%20Center&topic=Server%20Networking&CommCmd=MB%3Fcmd%3Dpass_through%26location%3Doutline%40%5E1%40%40.1dddee0b/0#selected_message

HTH

Syed

View solution in original post

Syed Iftekhar Ahmed · ‎10-03-2008

I posted an answer on the same issue a while ago.

Following is the link

http://forum.cisco.com/eforum/servlet/NetProf?page=netprof&forum=Data%20Center&topic=Server%20Networking&CommCmd=MB%3Fcmd%3Dpass_through%26location%3Doutline%40%5E1%40%40.1dddee0b/0#selected_message

HTH

Syed