10-03-2008 08:27 AM - edited 03-15-2019 01:43 PM
Hi all. I've just rigged up a 2811 with CCME. I've configured some ephone dn's and some ephones, all working fine.
I've downloaded the SoftPhone. Ive installed it, but when i open it, it doesnt show me any lines to select.
I've created an ephone with my laptop mac address and te type set to cipc:
ephone 5
mac-address 0011.4357.610A
username "huw" password huw
type CIPC
button 1:5
ephone-dn 5 dual-line
number 205
label 205
name 205
!
I've fired up my softphone client, but I dont get any lines offered.
The phone system and my laptop are all on 1 flat network, so no routing issues. Any ideas?
10-03-2008 09:39 AM
Please post the results for the following:
close CIPC
add following debug to router. *debug ephone register mac-address 0011.4357.610A*
open CIPC
10-06-2008 04:11 AM
I think ive solved it, IP Communicator 2.1 works fine, the SoftPhone may just not work with CCME
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: