cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
374
Views
0
Helpful
3
Replies

1242 A radio does not come up

jcowtan
Level 1
Level 1

I have converted a 1242 to LWAPP. I had it join the WLC which is running many 1132's.

I notice that the b/g radio is up but the A radio of teh 1242 is not.

I see in teh radio interfaces for this AP, the a radio has Admin status enbaled; Oper Status DOWN; and Regulatory Domain - Not Supported??

Why is the 1242 a radio not coming up?

3 Replies 3

scottmac
Level 10
Level 10

What is the firmware version of the radio? OLder A radios (with part numbers ending in "20" , I think)? It might be that the older 'A' radios are not supported.

If it is a hardware Rev issue, you can get update/upgrade radios from places like CDW (www.cdw.com).

What version of LWAPP code did you install?

I would also check on the WLC what the Country Code the LAP is set to.

-Scott
*** Please rate helpful posts ***

This is a "new" 1242 - but it did not get shipped with LWAPP

For the 1242 we get:

IOS 12.4.16b JA

Boot 123.7.1

SW 5.1.151.0

The WLC is running 5.1.151.0

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Review Cisco Networking products for a $25 gift card