I'm trying to setup a working international dial-peer on ccme.
Every time I try to dial the following on my debug output I see it match the following dialpeers:
I found a preconfigured dial-peer, dialpeer 64 and also tried creating a dial-peer, dialpeer 5004.
When I try to dial, I can dial 901 but once I dial the 4th digit 9011 it gives a slow busy signal.
This is a UC520 CME system.
You can delete dial peers 1000-1008. You will need 2 dial peers - one for incoming calls from the SIP trunk, one for outgoing calls to the SIP trunk. So, dial peer 5004 as mentioned in your last post would work for outgoing calls destined for DNs 5000-5999 on CUCM. You would need another dial peer for incoming calls from CUCM such as:
dial-peer 5005 voip
incoming-called number ..
session protocol sipv2
This would cover calls to DNs 100-199, 200-299, 300-399 and 900-999 on the CME.
Hope this helps.