Pls help

Unanswered Question
Oct 6th, 2008
User Badges:

I m having internet router 2600 series..

Which has 2 mbps leased line circuit.. Recently we have upgraded 2 mpbs to 4mbps.. Now traffic is flowing through both interfaces int s0/0 and s0/1..


which is having static route

ip route 0.0.0.0 0.0.0.0 s0/0

ip route 0.0.0.0 0.0.0.0 s0/1


How traffic is flowing through both interfaces .. Both having static route and administrative distance also same.. when the packet reaches router,how packets forwarded to the interfaces..


  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
satish_zanjurne Tue, 10/07/2008 - 00:17
User Badges:
  • Silver, 250 points or more


Hi,


1.In show interface are you seeing input/output count increasing for both interfaces ?


2.You can usually use the show ip route command to find equal cost routes , as added by you as static default routes.


3.There is an asterisk (*) next to one of the route block entries . This corresponds

to the active route that is used for new traffic by the router.


4.The term 'new traffic' corresponds to a single packet or an entire

flow to a destination, depending on the type of switching configured.


5.For process-switchingload balancing is on a per-packet basis and the asterisk (*) points to the

interface over which the next packet is sent.


6.For fast-switchingload balancing is on a per-destination basis and the asterisk (*) points to the

interface over which the next destination-based flow is sent.


7.Based on routing table lookup for process switching packet will be sent to appropriate interface


HTH...rate if helpful..

vinothlb1 Tue, 10/07/2008 - 00:46
User Badges:

input /output count is increasing on both interfaces..


As per your suggestion only one static route at a time will it work???


How the traffic count increasing on both interfaces..?

Actions

This Discussion