Problem with 3560 switch

serenity001 · ‎10-07-2008

hi

i have a a switch with a corupted image on it, i did the steps of sending a new image through the xmodem ..

but i booted from the new image i got this msg

--------------------------

Loading "c3560-ipbasek9-mz.122-25.SED1.bin"...c3560-ipbasek9-mz.122-25.SED1.bin: no such device

Error loading "c3560-ipbasek9-mz.122-25.SED1.bin"

Interrupt within 5 seconds to abort boot process.

Loading "flash:/c3560-ipbasek9-mz.122-35.SE5.bin"...@@@@@@@@@@@@@

-----------

i don't know why its looking for the old ios ...

also when i reloded the switch and get the switch# prompt, i did show runn i noteced a command on some ports which i didn't put ( i have configured the vlans and other stuff butt didn't configuer this vlan)

--------------

switchport trunk pruning vlan 2-941,943-1001

-------------------

please see the attached for more information

lamav · ‎10-07-2008

Hi:

Can you execute the following commands and post the output?

sh ver

sh flash

sh boot

dir /all

Thanks

VL

serenity001 · ‎10-08-2008

hi lamav

thx for your response, the attached is what you have requested

regards

serenity001 · ‎10-10-2008

hi ...

any update ??

enkli · ‎10-10-2008

you must enter config mode and then

issue

boot system flash:/your_new_image.

write te config and then reload.

rate if it helps

regards

serenity001 · ‎10-10-2008

thx ,

will do it then will give you the feed back

but also after rebooting, and issuing show runn

i see this command under some of the interfaces

switchport trunk pruning vlan 2-941,943-1001

and i didn't write tis command ever..

regards

enkli · ‎10-10-2008

I think you are rely on an old config.

but you can also disable pruning.

Rg

serenity001 · ‎10-10-2008

thank you

but still i have a problem :(

see this

!

interface FastEthernet0/7

switchport access vlan 44

switchport trunk allowed vlan 1-4077,4079-4094

switchport mode access

!

i didn't issue the trunk command ... is it a bug??

serenity001 · ‎10-14-2008

any update >??

enkli · ‎10-14-2008

I think that they arent issued themselves.

disable this config.

It might have be an error or bug if not an security issue