Hunt Group

Unanswered Question
Oct 8th, 2008

Hi,

I am configuring a hunt pilot, say 8888 and I would like incoming PSTN calls to 12345678 to use the hunt pilot number 8888 to reach DNs in the hunt list.

I know this can be done using a translation rule in the h323 gateway,

Is it possible to use Call manager to do the transformation or translation instead. How do you transform 12345678 to 8888 ?

Any help appreciated.

Thanks,

Paul

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
jguggehe Wed, 10/08/2008 - 05:14

Good morning, Paul.

Do you intend to run the gateway as H.323 or MGCP?

PAUL CHEN Wed, 10/08/2008 - 05:27

It is running h323. If I decide not to use a translation pattern at the h323 gateway.

How do you go about doing it in call manager ?

Thanks

Marwan ALshawi Wed, 10/08/2008 - 05:21

simple

on the gateway setting page make sure that the significant digit set to all

and on the dial-peer on the gateway make sure that the gateway will sedn the whole number to ur CCM

on callmanager creat a trnaslation pattren with pattren set to 12345678

give the translation pattren a partion the is accessable by the gateway CSS the gateway CSS must include this translation pattren partion

give the translation pattren a CSS that has access to the hungroup partion

now in the buttom of the translation pattren settin page there a called number trasnformation mask put it as 8888

thats it

but make sure u have check every point i mentioned above to get it work

good luck

if helpful Rate

jguggehe Wed, 10/08/2008 - 06:46

Great reply - beat me to it while I was away from my keyboard.

+5 from me!

Actions

This Discussion