fxo port ringing state

Unanswered Question
Oct 8th, 2008

I have a FXO port connected directly to an exchange line, when I ring this line and look at the "show vOICE PORT SUMMARY" output I get the following:

Operation Status Status

Dorm ring-det on-hook

up idle on-hook

it alternates between these two states when ringing, is this correct???

ta

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
sebastiandm Wed, 10/08/2008 - 08:58

Could you provide a sh run of your fxo port....also, where are you pointing this to,fxs/ccm please specify....

reidg Thu, 10/09/2008 - 08:45

voice-port 0/1/0

no echo-cancel enable

cptone GB

timing hookflash-out 50

timing sup-disconnect 50

connection plar 8776

impedance complex2

ccm should be answering and pass to a DN, ignore the PLAR in this setup.

regards

Actions

This Discussion