Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
700
Views
0
Helpful
2
Replies

fxo port ringing state

reidg
Level 1
Level 1

‎10-08-2008 08:14 AM - edited ‎03-15-2019 01:49 PM

I have a FXO port connected directly to an exchange line, when I ring this line and look at the "show vOICE PORT SUMMARY" output I get the following:

Operation Status Status

Dorm ring-det on-hook

up idle on-hook

it alternates between these two states when ringing, is this correct???

ta

Labels:
0 Helpful
2 Replies 2

sebastiandm
Level 1
Level 1

‎10-08-2008 08:58 AM

Could you provide a sh run of your fxo port....also, where are you pointing this to,fxs/ccm please specify....

0 Helpful

reidg
Level 1
Level 1
In response to sebastiandm

‎10-09-2008 08:45 AM

voice-port 0/1/0

no echo-cancel enable

cptone GB

timing hookflash-out 50

timing sup-disconnect 50

connection plar 8776

impedance complex2

ccm should be answering and pass to a DN, ignore the PLAR in this setup.

regards

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents