Trunkgroup configuration

Answered Question
Oct 8th, 2008
User Badges:

According to Cisco documentation the trunkgroup command assigns an outgoing dial peer as a member of one or more trunk groups.


My question: can I use this command to assign one or more trunk groups to an incoming dial peer?


Thanks in advance.

Correct Answer by Marwan ALshawi about 8 years 7 months ago

Trunk groups apply only to outbound calls. The gateway cannot control channel assignment of incoming calls.


source cisco press


if helpful Rate

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
Correct Answer
Marwan ALshawi Wed, 10/08/2008 - 15:44
User Badges:
  • Purple, 4500 points or more
  • Community Spotlight Award,

    Best Publication, December 2015

Trunk groups apply only to outbound calls. The gateway cannot control channel assignment of incoming calls.


source cisco press


if helpful Rate

guillermohurtado Thu, 10/09/2008 - 06:32
User Badges:

What if I have for incoming E1s links and I am expecting "X" number from any of these links? And I want to create just one dial-peer?

guillermohurtado Thu, 10/09/2008 - 06:34
User Badges:

What if I have four (4) incoming E1s links and I am expecting "X" number from any of these links? And I want to create just one dial-peer?


Actions

This Discussion