cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
338
Views
0
Helpful
3
Replies

Trunkgroup configuration

According to Cisco documentation the trunkgroup command assigns an outgoing dial peer as a member of one or more trunk groups.

My question: can I use this command to assign one or more trunk groups to an incoming dial peer?

Thanks in advance.

1 Accepted Solution

Accepted Solutions

Marwan ALshawi
VIP Alumni
VIP Alumni

Trunk groups apply only to outbound calls. The gateway cannot control channel assignment of incoming calls.

source cisco press

if helpful Rate

View solution in original post

3 Replies 3

Marwan ALshawi
VIP Alumni
VIP Alumni

Trunk groups apply only to outbound calls. The gateway cannot control channel assignment of incoming calls.

source cisco press

if helpful Rate

What if I have for incoming E1s links and I am expecting "X" number from any of these links? And I want to create just one dial-peer?

What if I have four (4) incoming E1s links and I am expecting "X" number from any of these links? And I want to create just one dial-peer?

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: