10-08-2008 02:03 PM - edited 03-15-2019 01:49 PM
According to Cisco documentation the trunkgroup command assigns an outgoing dial peer as a member of one or more trunk groups.
My question: can I use this command to assign one or more trunk groups to an incoming dial peer?
Thanks in advance.
Solved! Go to Solution.
10-08-2008 03:44 PM
Trunk groups apply only to outbound calls. The gateway cannot control channel assignment of incoming calls.
source cisco press
if helpful Rate
10-08-2008 03:44 PM
Trunk groups apply only to outbound calls. The gateway cannot control channel assignment of incoming calls.
source cisco press
if helpful Rate
10-09-2008 06:32 AM
What if I have for incoming E1s links and I am expecting "X" number from any of these links? And I want to create just one dial-peer?
10-09-2008 06:34 AM
What if I have four (4) incoming E1s links and I am expecting "X" number from any of these links? And I want to create just one dial-peer?
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide