10-08-2008 06:48 PM - edited 03-06-2019 01:50 AM
I have a cisco 2960 switch.
I can ping this switch without any loss.
No issue in connectivity. when the telnet command is issued it telnets the switch and ask the telnet password. But when I am typing the password i get disconnected automatically.
Please help to solve this.
10-08-2008 11:54 PM
Do you have the basic telnet config
2960#config t
2960(config)#line vty 0 4
2960(config-line)#password xxxxx
2960(config-line)#login
If its there make sure that there isnt any device using the same ip as switch
Syed
10-09-2008 03:18 AM
While you are at it set your enable secret password also .
10-10-2008 03:52 AM
I think it's problem related to ip conflict
Please check the change the switch ip and check again
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: