PIX 501 & Branch Office

Unanswered Question
Oct 9th, 2008
User Badges:

Hi,

Attached is the network diagram and Pix Configuration. We have data circuits for all our branches just installed. The problem is that the Pix just stops to ping the branch Office routers.


1. From the Pix can ping 192.168.1.2 & 1.3


2. From 192.168.1.2 & 1.3 can ping all the networks.


3. From the Pix cannot reach the branch routers.


Appreciate all your support.


Regards


Sarfaraz



  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
singhsaju Fri, 10/10/2008 - 06:56
User Badges:
  • Silver, 250 points or more

Hi Sarfaraz,


Add following command to the PIX and then check and post results:


icmp permit any inside


HTH

Saju

pls rate helpful posts

John Blakley Fri, 10/10/2008 - 10:34
User Badges:
  • Purple, 4500 points or more

What side of the branch routers can you not reach? If you source your ping on the pix, does it work? (ping outside 192.168.x.x)


Do a debug icmp trace (I think), and it will show you where you're losing your packets.


John

Actions

This Discussion