10-09-2008 12:22 AM
Hi,
Attached is the network diagram and Pix Configuration. We have data circuits for all our branches just installed. The problem is that the Pix just stops to ping the branch Office routers.
1. From the Pix can ping 192.168.1.2 & 1.3
2. From 192.168.1.2 & 1.3 can ping all the networks.
3. From the Pix cannot reach the branch routers.
Appreciate all your support.
Regards
Sarfaraz
10-10-2008 06:56 AM
Hi Sarfaraz,
Add following command to the PIX and then check and post results:
icmp permit any inside
HTH
Saju
pls rate helpful posts
10-10-2008 10:34 AM
What side of the branch routers can you not reach? If you source your ping on the pix, does it work? (ping outside 192.168.x.x)
Do a debug icmp trace (I think), and it will show you where you're losing your packets.
John
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide