Hi 2 all,
we have several 2821 routers, which have multicast (pim sparse) mode enabled.
We are using igmp version 2 on the routers client interfaces, where the receiver is connected to.
we have two problems:
the problem is, that the client has apple quicktime installt as the viewer.#
it seems that quicktime only send igmp v3 to the routers interface, which is configured for igmp v2.
we have to use igmp v2 for other reasons.
so the question:
does anybody know how to configure quicktime to use only igmp v2 ???
when we start quicktime at the receivers side, the router "thinks" that this software is a sender too!!
but we only want to receive.
thanks for any answer and greetings from austria!