Netflow Problems

Unanswered Question
Oct 9th, 2008
User Badges:

Hi,


We have 4 Cat6506E's running 12.2(18)SXF14 and want to enable netflow on certain interfaces (gigabit blade) but cannot as when configuring at the interface there are no commands available to enable netflow.


Commands already enabled are

ip multicast flow-stat-timer 9

mls flow ip full

no mls flow ipv6

no mls acl tcam share-global

mls cef error action freeze


ip flow-export source Loopback0

ip flow-export version 5

ip flow-export destination xxx.xx.x.xx 9996






Can anybody help please ?

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Collin Clark Thu, 10/09/2008 - 07:48
User Badges:
  • Purple, 4500 points or more

The interface command is ip route-cache flow


Hope that helps.

Gerard Gacusan Thu, 10/09/2008 - 07:54
User Badges:

If it's a layer-2 switchport, then not possible to enable netflow and i have same issue this before. Layer3 and Virtual Interfaces are supported only.


Try a "no switchport" command on the interface, ip route-cache flow becomes available.


Hope this helps ...


thanks ..


gerard




Actions

This Discussion