Configuring a WIC -1DSU T1 on 2610

Unanswered Question
Oct 9th, 2008

I'm trying to configure a Serial port on this router but it's not taking the following statements:

Interface serial 0/0

service-module t1 clock source internal

service-module t1 framing esf

service-module t1 linecode b8zs

I don't get an error message but when I do a show run it doesn't show up. Is this a default?

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Giuseppe Larosa Thu, 10/09/2008 - 09:31

Hello Roland,

yes these should be default settings

try to use

sh controller ser0/0 to check these parameters

Hope to help



This Discussion