10-09-2008 02:51 PM - edited 03-03-2019 11:52 PM
I have two cisco 2610XN router but both are not booting properly and it shows the following attached error, How can i fix this problem .Please suggest me .
10-09-2008 05:08 PM
it could be software issue, I would suggest to load/install a new fresh IOS code, if you are getting a forced software crash reload which seems like the router is reloading in a loop bring the router to rommon> and install new image, try installing a different version from the current running version.. in the event that after reloading router with new image and do have same issue it could then be hardware, I have seen similar issues caused by software bugs or corrupted IOS codes and have been solved by reloading fresh code, try that.
HTH
Jorge
10-09-2008 07:25 PM
hi,
there's an error msg "Unexpected NM Interrupt received from slot: 1".
may be you can try to unplug the module and reload again.
cheers.
10-10-2008 12:54 PM
Ok , I did but problem not resolved.Thanks for reponse plase suggest me next step.
Regards,
Sujeet
10-10-2008 07:23 PM
Hi,
1.If you have newly installed the IOS & still it is giving problem
2.If you have removed the module, reinstalled & rebooted , still it is giving problem.
3.If you have removed the module , & then booted the router, but still it is giving problem
4.Then RMA the router & get the replacement
HTH...rate if helpful..
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide