cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
286
Views
0
Helpful
2
Replies

static command?

yeundu
Level 1
Level 1

i know means of below static nat

static (high, low) low high

but,

i want to know means of below command

static (high, low) high high

static (inside,dmz) 172.17.211.0 172.17.211.0 netmask 255.255.255.0

2 Replies 2

abinjola
Cisco Employee
Cisco Employee

static (inside,dmz) x.x.x.x x.x.x.x

the above is called self static which means whenever source behind inside x.x.x.x goes to dmz it will remain unnatted, this is as good as nat 0 acl

Fernando_Meza
Level 7
Level 7

Hi ..

Basically this is commonly used for allowing access to the REAL IP addresses of your inside devices from a lower security level interface (i.e DMZ) . You need this type of configuration when traffic is initiated from lower to higher interface and you need to connect to the REAL IP address of the destination hosts .. if you don't configure this static you will not be able to connect to the real IP addresses of the hosts behind the lower interface.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: