cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
20466
Views
9
Helpful
19
Replies

Excessive collision in the Router

UCBNOCWAN
Level 1
Level 1

Hi All in Router i am the getting error:AMDP2_FE-6-EXCESSCOLL: Ethernet0/0 TDR=1, TRC=0

Router is connected to Switch, both router and switch config is below

can some body tell me how to fix up this issue as i am planning to change Duplex setting router from half duplex to full duplex

will this solve my problem

Router config:-

interface Ethernet0/0

description ### LAN ###

ip address 10.21.1.2 255.255.0.0

ip access-group 141 in

ip route-cache flow

half-duplex

standby ip 10.21.1.1

standby preempt

end

====================

Switch config

interface GigabitEthernet0/1

description ***FREE***

no logging event link-status

no snmp trap link-status

no mdix auto

spanning-tree portfast

spanning-tree bpdufilter enable

spanning-tree guard root

==================

Erros

AMDP2_FE-6-EXCESSCOLL: Ethernet0/0 TDR=1, TRC=0

AMDP2_FE-6-EXCESSCOLL: Ethernet0/0 TDR=1, TRC=0

AMDP2_FE-6-EXCESSCOLL: Ethernet0/0 TDR=1, TRC=0

AMDP2_FE-6-EXCESSCOLL: Ethernet0/0 TDR=1, TRC=0

19 Replies 19

andrew.prince
Level 10
Level 10

Ermmm you already know the issue - Change the duplex to full or auto on the router and switch port.

HTH>

Will this soultion work

Yes. Either change both to auto neogotiate or change the router to full duplex.

Jon

Faster typing again Jon!

:o)

I've been practicing :)

Set the router ethernet speed/duplex to 10/full

Set the switch port speed/duplex to 10/full

This will fix your issue.

HTH>

Hi,

Is it necessary to change on Switch side as i belive switch can do auto negotiate and also no speed settings has defined on the swtich side

If you want to auto-negotiate then set the router interface to auto-negotiate ie. get rid of the "duplex half" statement.

I would do as Andrew suggested though - set both to 10full.

Jon

Hi

Thanks for the replies,

but this router suports only full Force full duplex operation//half Force half-duplex operation

So please let me know is it required to change at swtich end also

If you are setting the router interface to full duplex then do the same on the switch port.

Jon

Dear All,

Thanks very much for the all for giving the replies.

lastly will be there any impact on the network interms of outage if executing this change on both router and switches

Yes, traffic will be disrupted when you make the change. Probably best to do it out of hours.

Jon

Thanks Jon,

Willbe doing the change after business hours, could you please let me know how much will be the down time

It's more of quick interruption in traffic forwarding rather than full downtime. About 1 min per change should be more than enough.

Jon

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco