cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
505
Views
0
Helpful
2
Replies

Syslog server for access points

brock0150
Level 1
Level 1

Hello,

On the controller, when you look at an access points config. There is the syslog server for the access point with the default ip address of 255.255.255.255. I was wondering if there was any way to disable the syslog server for the access points. The only thing I've found so far is that the ip address of the syslog server can be changed.

Thanks,

2 Replies 2

didyap
Level 6
Level 6

To remove a syslog server, use the no logging host global configuration command, and specify the syslog server IP address. To disable logging to syslog servers, enter the no logging trap global configuration command.

i am not sure if "no" command works.

but on 5.2 ver

config logging trap disable global

disbale/ enable is the key to set the ip address for syslog server

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: