cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
471
Views
0
Helpful
2
Replies

backplance utilization on cat4500

Robert Saurer
Level 1
Level 1

Is it possible to monitor the backplane utilization of a catalyst 4500 switch?

SupV-10GE

I only know the Utilization LEDs on the Supervisor.

Robert

2 Replies 2

bwilmoth
Level 5
Level 5

You may try using the “show environment” CLI command to monitor the system and to find the power consumed by the backplane in Supervisor Engines II-Plus to V-10GE.

Command: show environment [alarm | status | temperature]

Temperature - Displays temperature of the chassis

bwilmoth is correct "show environment" will show you switch bandwidth utilization . Don't ask me why they stuck it under the show environment command , thats not intuitive at all.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco