R-PVST or MST

Unanswered Question
Jon Marshall Fri, 10/10/2008 - 11:19
User Badges:
  • Super Blue, 32500 points or more
  • Hall of Fame,

    Founding Member

  • Cisco Designated VIP,

    2017 LAN, WAN

Ali


1) The network command is used to tell EIGRP which interfaces to run EIGRP on. You nearly always have this part of the confguration under your "router eigrp " configuration.


The neighbor command is used to send unicast updates to a specfic neighbor. This is not as common in the configuration.


2) MST - if you choose MST all switches should be configured with the same parameters.


R-PVST+ - you can configure 2 of your switches with R-PVST+ and leave the other 2 to run PVST+ but any vlan that exists on both R-PVST+ and PVST+ switches will default to 802.1d timers eg approx 50 seconds for convergence.


Jon



Actions

This Discussion