R2 Digital w/o ANI and Voice Mail in SRST mode

Unanswered Question
Oct 11th, 2008


I'm facing the following problem. I have router in SRST mode and I want to reach the Cisco Unity through PSTN (R2 Digital without ANI). I have tried the vm-integration but it doesn't work. Also tried to prefix in dial-peer with pauses ",,,," but still no success.

Is there a way to transfer the DTMF digits inbound after the call is established on R2?

Thanks in advance.

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
dknov Fri, 04/10/2009 - 15:17


I have a similar problem. ANI exists, but it is not really important cause I am doing vm-integration so DTMF digits should be passed on to activate call forwarding on Unity, so the actual ANI does not make any difference.

I see the call is made from SRST router and it gets to Unity, but it always plays out the Openning Greeting handler and I don't think that DTMF digits are actually being passed. I also used Port Monitor tools in Unity Depot and it does not show any DTMFs arriving on that call....

Had anyone seen this before?




This Discussion