using FXS ports on 2nd VIC card

Unanswered Question
Oct 12th, 2008
User Badges:

I have a UC500 with two 4-port FXS cards. The 4 ports on the first card were automatically setup and ephones were configured using the MAC address of the first card. Now I want to use the FXS ports on the 2nd card but I don't know how to get the MAC addresses for the second card. When I do "sho stcapp device summ" I only see the first four ports. What do I need to do here?


Thanks,

Diego


  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 3 (1 ratings)
Loading.
Marwan ALshawi Sun, 10/12/2008 - 22:59
User Badges:
  • Purple, 4500 points or more
  • Community Spotlight Award,

    Best Publication, December 2015

with FXS ports u dont need any mac address and even done need ephon !!!!

can u post ur config

fxs for analog phones


if u have fxs port 0/0/0 connected to analog phone and u want to give it ext. number as 333


u need pots dial-peer as following


dial-peer voice 9 pots

destination-pattren 333

port 0/0/0


good luck

DIEGO ALONSO Mon, 10/13/2008 - 07:37
User Badges:

I understand that it will work. However, I want to use the DN and ephone for consistency with the other analog devices. You also get internal caller-id and the extensions are logged in the directory.


Thanks,

Diego

Actions

This Discussion